Installation Instructions
|
| Step 1: Clean the surface with alcohol
or window cleaner. Tape Decals in place with masking tape. Using
the bottom of the decal as a guide, make adjustments to ensure it's
straight and level. |
 |
| Step 2: Once your decal is level
and in the desired spot. Tape the Center down. This will act as
your 'hinge' and will also hold the decal in place. |
 |
| Step 3: Take either side and peel
back the top layer. This will pull the graphics up with it. Pull
It back to the center tape, and cut and remove that portion of the
backing wax paper. |
|
| Step 4: Hold the transfer paper
just above the surface with little slack. Squeegee from the center
out in a up and down motion. Use enough pressure to force air bubbles
out from underneath the graphic. |
|
| Step 5: Remove the center tape and
peel back the remaining side. Discard the wax paper backing. repeat
step 4, Squeegee from the center out in an up and down motion. |
|
Step 6: Squeegee the graphic
down one more time to make sure its properly adhered. Spray the
transfer paper with a water bottle (optional) and then pull the
transfer paper back on itself. Pop any air bubbles with a pin
and rub the air out with your finger. That's it! You've successfully
installed your graphic!
Back to the top |
